Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Thomson | ICC9 | Trips on & off aft 1 min | OK when you s/c TR96 sm st/by tr - TV92 sm was the cause even tho it check ok out of cct | ||
Thomson | ICC7 | field TDA 8172 | note from SM page 3 : If pin 8 på IC 7600 is at 0 volt, then there is a fault in the PROT circuit. | ||
Thomson | ICC19 28DG35UD | Dead with led flashing | unplugging Dolby module restored pic. TDA2615 amp chip IS450 blasted - pt no 10257880 | ||
Thomson | ICC19 28DG35UB | Tuning mode | From st/by hold down menu button & the set will turn on in preset mode. Follow on screen prompts | ||
Thomson | ICC19 28DG35UB | PIN code unsetting - "Type in 4 digit code" message | Hold down both prog & vol minus(-) button on TV & switch on. Release buttons & you should be in service mode.Navigate with arrow buttons on remote to "Setup" then select "Erase Pin" by holding down the right arrow button for 5 secs until yellow tick appears in box.You must backtrack to find the "Quit" option to exit & store the new info. | ||
Thomson | ICC19 28DG35UB | Int shows pic but usually error code indicating faulty Txt | Replace Txt panel | ||
Thomson | ICC17 32WS23U | Trips 3 times then dead | LOPTr & LOPTx faulty | ||
Thomson | ICC17 32WS22U | Dead - at sw on LED turns green then flashes amber twice, goes green then flashes amber 6 times & repeats | Dry joints CRT base | ||
Thomson | ICC17 28WS23U | Tuning procedure | Sw off TV mains whilst in st/by. Hold chan - on TV whilst sw on. Full auto tune menu appears | ||
Thomson | ICC17 28WS23U | Shuts down at sw on aft EHT rustles up | LOPTx replaced stopped shutting down but still no sound/vis - CB01 10nF 3kv in A1 supply on crt base leaky | ||
Thomson | ICC17 28WS23U | Dead apart from Red LED that does not change | LOPTx low res turns all ways round | ||
Thomson | ICC17 28WR25UG | Dead - no st/by light | DP21 37v zener BZX85C39 also check RP20 470R. | ||
Thomson | ICC17 28WF25U | Int reverts to st/by with red LED flashing | May run again for a while when sw back on - leakage in focus spark gap. Fit new crt base pt no 80298800 | ||
Thomson | ICC17 28WF25U | Dead with all volts appearing at psu o/p at 1/2 normal value briefly at sw on | The 39v I/p to TP21 chopper Tr in st/by psu low at 11 v - DP21 39v zener leaky | ||
Thomson | ICC17 28VK24 etc | Dead with red LED blinking 2 then 7 pulses | LOPTx - comes with mod kit 35175720. Also check FOP chip IF01 & cct prot ZL11 for damage by LOPTx |