Dicas Reparação JVC




Modelo - Chassis


Pesquisa: JVC Enviar Dica Resolvida
Resultados 402
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
Jvc HRJ205
Dead, no negative voltages on psu connectorCheck R32 100 ohms in psu for o/c
Jvc HR-S4700EK
Intermittently crunches tapes on ejectI had to use a clear service cassette to see what was occuring during the eject sequence and found that during the unthread, the take up reel was rotating anti-clockwise and was not being braked, the felt pad on the take-up sub brake had fallen off the arm, a new brake cured the problem
Jvc HRJ235EK
Rubbing noise at start of full tape with horizontal picture judderExcessive take up tension! Replace take up clutch item 25, Pt no PQ46323A-1
Jvc C-V14EKS/B/W Onwa
No RedI was hoping the nvm had become corrupt and turned the red drive down but it was fine To enter service mode press and hold vol up and vol down on the front panel and switch set on. Thankfully ZD405 8V2 had expired almost s/c and removed the red
JVC
Dead - st/by onlyR323 6k8 5w fusible res o/c connects pin 42 of IC301 to HT rail
JVCSX2, TS2
Crackle on NICAMReplace SAWF with pt no CE42606-T01
JVCS2180M
Field collapseCheck UPC1488H FOP chip & supply to it - if missing, check cp IC 10NR for o/c
JVCOnwa
St/by onlyNo line feed - 6k8 2w resistor in middle of pcb discoloured & o/c
JVCOnwa
Sound int & paired lines at bottomR434 0R68 ½w hi res
JVCMX2
Flyback lines at bottom of screenIncrease value of C442 from 150pf to 470pf
JVCMX2
Field int collapsesD441 RD3.0ES(B2) goes leaky when warm - to pin 13 TA8859P IC461
JVCJX
Blank raster when A1 advanced - sound okTDA4580 RGB vid controller chip
JVCJA
Field scan missing from topIC401 (fop chip) pin 4 = 14.5v, pin 8 = 42v but was low because FR553 5R6 ½w o/c. eplaced along with TDA8350Q fop chip
JVCCY21EK
Int goes to st/byDry joint X401 resonator by IC401 caused int line drive
JVCCX60GB
AC adaptor no o/pQ01 2SC2688 o/c


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads