Dicas Reparação DAEWOO
Modelo - Chassis
Pesquisa: DAEWOO Enviar Dica Resolvida
Resultados 140
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Daewoo | GB14H1T | Service mode entering | On hset press Blue > Yellow > Green > Red > Stby sequencially. When brought out of st/by should be in service mode. Use buttons 1 & 4 for Slope Adjust; 2 & 5 for Vert Centre; Use buttons 3 & 6 for Vert Amp... | ||
| Daewoo | GB14H1N | Won't come out of st/by, sw off when playing, OSG corrugated - all int | I826 3.3v reg LE33CZ on front of pcb - available From Farnell | ||
| Daewoo | GB14H1N | Sound absent & snowy pic aft re-assemby | Check pl/skt conns of spk - can be accidentally put in set AGC skt | ||
| Daewoo | GB14H1N | Service mode entering | Press "Norm-av-sleep-clear-stby" on R/C | ||
| Daewoo | GB14H1N | No tuning - supply & clk/data lines ok | Tuner faulty - replaced Type DT5-BF18D pt no 48597-19930 | ||
| Daewoo | GB14F8T1 | No Vol adj - osg stuck ½ way | IC1703 24C08P eeprom - pre-prog by Daewoo from SEME @ £18 | ||
| Daewoo | GB14F7T1 CP420 | St/by only | R804 47k start up res | ||
| Daewoo | GB14F7T1 | Won't sw on with tape stuck - st/by only | No volts at 6v reg IC1806 - P803 plug/skt has 8v in but no 8v o/p due to dry joint on/off sw | ||
| Daewoo | GB14F7T1 | Sound disappears int | (IC) I501 a TDA8374A mounted on the VCR pcb. | ||
| Daewoo | GB14F7T1 | Dead - psu ok but no lop | hairline crack by LOPTr coll tp LOPTx | ||
| Daewoo | DWX28W5GB | Impurity | check degaus coil not trapped by set back causing them to go o/c | ||
| Daewoo | DVT2082P | Red missing | Q552 2SA1266 on crt base | ||
| Daewoo | DVT2082P | Int dead | Dry joint C817 100µ - remove plastic strut to see | ||
| Daewoo | DVT1482P CP310 | Sound absent in TV mode - ok in pback | Check RHS edge connector for dry joints/damaged print on video unit | ||
| Daewoo | DVT1482P | Dead with burning smell | LOPTx |