Dicas Reparação HITACHI
Modelo - Chassis
Pesquisa: HITACHI Enviar Dica Resolvida
Resultados 1003
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| PHILCO HITACHI | PC 1441 CPH04 | Não liga, ao remover da tomada faz um barulho agudo que dura uns 3 segundos | Flyback com fuga | Troca do flyback | Luis |
| HITACHI | 32LD9700 42LD9700 | No sound | bad soldering on cristal X800 (HDMI board). | ||
| HITACHI | 32LD9700 | No sound bad conection in PFA1(HDMI board) pin 2 | just take it out press and put it back. | ||
| HITACHI | 28LD5200 | No colour Colour drops out after the unit has been running for two to three hours. | Resolder capacitor C510 and other components in its vicinity. | ||
| HITACHI | 26LD6600 32LD6600 | Lines, no pictures back light present | resoldered IC224 (videoprocesor). | ||
| HITACHI | 26LD6600 32LD6600 | Lines on the screen | Cable from the main board to screen super glue it. | ||
| HITACHI | 26LD6600 32LD6600 | Looks like no Synchro impulse eeprom fault | Just go in service menu(menu,4,7,2,5) option | Factory reset. | |
| HITACHI | 26LD6200 32LD6200 | Unit does not work, standby LED not lighting | Replace Ferrite bead L500 and L501 with a jumper wire. | ||
| HITACHI | 26LD6200 32LD6200 | No pictures or lost after 10,20sek | replaced inverter board(P.Suplly)17PW11 | 2 (24Volts) | |
| HITACHI | 26LD6200 | Lines on the screen,strange picture | Replaced cable from main board to the screen. | ||
| HITACHI | 22LD4500U | No sound | Very low sound on terrestial and no sound on Digital or any AV inputs | Replace memory IC302 Type 24LC16.All customer controls are set to minimum on the new IC. Please reset language and all picture controls to normal after replacing the IC. | |
| HITACHI | 22LD4200 | Stby redlight go green and back to red | Transistor(Q104 BC548) and Resistor (100oM). | ||
| HITACHI | 22LD4200 | Flashing green line | Green horizontal line flashing across the screen intermittently | Remove resistor R149 on the Input signal board and replace it with Jumper SMD (0 W) | |
| HITACHI | 22LD4200 | Lines on the picture | Bad conection between PS(PL108) and VIdeo board (PL100) . | ||
| HITACHI | 22LD4200 | No pictures sound ok | after diferent time CHECK 5v on 17amp07 p/s board if less 3,0 or 1,5 replaced C111(25v1000mkgf) |